Subscribe to Blog
Email Address
 
Search for HP End Mill returned 1 results.
Pages:(1) [1]

Test of NIAGARA 3FL HP End mill for Aluminum

February 27, 2012, 10:02 pm by Eldar Gerfanov (Admin)

Recenty ordered a 3Flute High Performance End Mill From NIAGARA.
Was very glad and slightly surprised that when punched in all of the endmill's data into my Calculator nothing broke down.I had a rason: At 5000RPM and 3/8" Deep slot cut. The feed came to around 92.0IPM. Chips were making this nice ringing noise that sounds like money.

Setup:
HAAS VM-3
Hudrolic Tribos Holder
3/4" 45DegHelix 3Flute 1.625FluteLen, 2.375"Overhang TICN HP End mill

S:5000RPM
F:92.0IPM
DOC: 0.375" Slotting
Coolant:FLOOD

The calculation was pretty much dead on.

Pages:(1) [1]
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here